Table of Contents
Advertisement
CONNECTIONS
Connection to a TV (for video)
Basic Audio
TV
R
L
Audio Cable
Video Cable
DVD
Analog Audio out
• Method 1 DVD Player + TV with Video Input Jack
• Method 2 DVD Player + TV with S-Video Input Jack
• Method 3 DVD Player + TV with AV1 Jack or DVD Player + TV with Component Video Jacks
NOTES
• S-Video output connector
The video signals are divided into colour (C) and brightness (Y) signals, achieving a clearer picture.
If the TV is equipped with a S-Video input connector, we recommend connecting it to the this product's S-Video output con-
nector using a commercially available S-Video connection cord.
• If you use the Euro A/V(SCART) jack, it is not necessary to connect the analog audio cable.
• Connect the DVD player directly to a TV. If the A/V cables are connected to a VCR, pictures may be distorted due to the
copy protection system.
• Be sure not to use both the Euro A/V(SCART) jack and component Video jacks for video output at the same time.
• When changing the VIDEO OUT setting (SCART or Component(I)/Component(P)), connect to a VIDEO jack or an S-VIDEO
jack on the TV. If the setting is changed, for example, to Component(I)/Component(P) while the Euro A/V(SCART) jack is
connected to the TV, a distorted video signal may be output.
Selecting Progressive Scan (625p/576p or Interlaced 625i/576i) Playback
• If your TV is compatible with progressive scanning (625p/576p), connect the TV to the Component Video Output jacks of
the DVD player and set "VIDEO OUT" to "COMPONENT PROGRESSIVE" in the display setting. Next, set your TV to the
progressive scan mode. Refer to page 17 for instructions on changing the display setting.
• If your TV is not compatible with progressive scan, set "VIDEO OUT" to "COMPONENT INTERLACE".
• Use a commercially available adaptor if the video input jacks of your TVs or monitors are the BNC type.
What is Progressive Scanning?
• Unlike conventional interlace scanning, the progressive scan system provides less flickering and images in higher resolution
than that of traditional (625i/576i) television signals.
HOW TO CONNECT TO A TV WITHOUT AUDIO/VIDEO INPUT JACKS
If your TV does not have RCA type audio and video input jacks it is still possible to connect this DVD player to your TV's
75-ohm coaxial antenna terminal using a commercially available Stereo Audio/Video RF Modulator, not included. Connect
the audio and video outputs of the DVD player to the audio and video inputs on the RF Modulator, and then connect the
coaxial output of the RF Modulator (usually marked "TO TV") to the 75 ohm coaxial antenna terminal on your TV. Follow
the instruction supplied with the RF Modulator for more details.
If your TV's 75 ohm coaxial antenna terminal is already occupied by an antenna or cable box connection, remove that
cable from your TV's antenna terminal and reconnect it to the coaxial antenna input terminal of the RF Modulator (usually
marked "ANT IN"), then connect the RF modulator to your TV's antenna terminal as described above.
NOTE
• The picture quality from DVD discs will not be as good if the DVD player is connected to the TV's antenna terminal
through an RF Modulator.
Method 1
Method 2
Good picture
Better picture
VIDEO IN
S-Video
Cable
VIDEO
OUT
Video out
S-Video out
21-pin Scart jack
S-VIDEO IN
Euro
audio/video
Cable
AV
S-VIDEO
OUT
Audio/Video out
– 11 –
Method 3
Best picture
COMPONENT
VIDEO IN
C
/P
Y
C
R
R
OR
Component
Video
Cable
RGB
TV
Euro
Component
Video out
/P
B
B
COMPONENT
VIDEO OUT
EN
Advertisement
Table of Contents
