Hitachi CP-X265 User's Manual And Operating Manual page 5

Ports (See below.)
AUDIO IN3 L/R port (13)
(In the default setting, the
AUDIO IN3 L/R port is the audio
port for the VIDEO, S-VIDEO
and COMPONENT VIDEO
ports, however it is possible to
change the settings. 36)
COMPONENT
VIDEO ports (13)
Y
C /P
B B
C /P
R R
VIDEO port (13)
S-VIDEO port (13)
AUDIO IN port (12)
(In the default setting, the AUDIO
IN port is the audio port for
the RGB IN port, however, it is
possible to change the settings.
36)
NOTE (*) About Restart switch: This projector is controlled by an internal
microprocessor. Under certain exceptional circumstances, the projector may not
operate correctly and the microprocessor will need to be reset. In such a case,
please push the Restart switch by using a cocktail stick or similar, and before
turning on again, make the projector cool down at least 0 minutes without
operating. Only push the Restart switch in these exceptional instances.
Rear-Left side
AUDIO IN port (12)
(In the default setting, the AUDIO IN port is the audio
port for the RGB IN port, however, it is possible to
change the settings. 36)
RGB IN port (12)
AUDIO IN3
Y R
RGB IN1
AUDIO IN1
C P
/
B B
L
AUDIO IN2
C P
/
R R
K
VIDEO
S-VIDEO
Kensington lock slot
Power switch (17)
Vent
Restart switch (*) (62)
RGB IN port (12)
RGB IN2
RGB OUT AUDIO OUT
CONTROL
USB
USB port (12)
CONTROL port (12)
Part names
AC inlet (14)
Elevator button (9)
Elevator foot (9)
LAN port (12)
Used for Ethernet
LAN
input/output.
This port is used
when utilizing
network functions.
AUDIO OUT port
(12)
Ports
RGB OUT port (12)
5