User Maintenance Instructions - Continental Electric CE27616 User Manual

WARNING:
1. Properly handling the bad fuse including its broken glass & metal to avoid the harm on hu-
man body.
c) If fuse cover located between the two blades of attached plug (applicable to plug type: SL-
024) as following picture, taking following steps to replace incompetent fuse.
Step one: Select a suitable tool (the top of the tool should be tapering and flat, for example,
travel scissors or small flat screwdriver etc.), insert the tip of the tool into gap in the plug face.
Step two: Press the tool down, then prize the protection door of the fuse out.
Step three: Continue pull the protection door until you can't draw it out, then you'll find the
whole fuse exhibited.
Step four: Insert the tip of your tool into fuse slot (close with the terminal), then prize the fuse
gradually and slowly, but not overexert. If you feel tight, you can try it at several times and
prize the fuse little by little.
Step five: When one side of the fuse has been prized, then you can get the fuse out entirely.
Step six: Put a new fuse into the slot (the new fuse should near the end of the plug), then use
your tool to press fuse into slot, you shouldn't press the glass tube of the fuse but the copper
cap at both sides, and not overexert, or else the fuse will be broke.
Step seven: Use your finger or a tool to push the protection door until the fuse be covered
completely, but sometimes the protection door will be tight or can't be go forward, please make
sure the fuse have been fixed at the right place. And you need push the protection door verti-
cally, or else it will be broke probably.
DO NOT OPERATE APPLIANCE IF THE LINE CORD SHOWS ANY DAMAGE OR IF AP-
PLIANCE WORKS INTERMITTENTLY OR STOPS WORKING ENTIRELY.
PLEASE NOTE: During the first few minutes of initial use, you may notice a slight odor. This
is normal and will quickly disappear.
OPERATING INSTRUCTIONS
1. Plug fan into an electrical outlet.
2. To operate the fan, to control fan speed; on LOW, on MEDIUM and on HIGH or use dial
located on front of fan. Turn fan switch to desired level: 1 =LOW, 2=MEDIUM, 3=HIGH.
To turn off fan, pull the chain pull or use the switch and turn to O=OFF.
3. To make fan oscillate, pull down the chain for oscillation.

USER MAINTENANCE INSTRUCTIONS

This appliance requires little maintenance and contains no user serviceable parts.
Do not try to fix it yourself. Refer it to qualified service personnel if servicing is needed.
This fan is permanently lubricated and will not require additional lubrication for the life of the
fan.
TO CLEAN: Before cleaning, turn fan off and unplug from electrical outlet. Wipe off excess
dust with a lint-free cloth.
To ensure adequate air circulation to the motor, keep vents located at the rear of the motor
housing free from dust accumulation. A vacuum cleaner hose can be used to clean these
vents. Do not submerge your fan in water or any other liquid. Disassemble grilles and blade.
Grilles and blade may be cleaned with mild soap and water. Use a soft, slightly damp cloth
to wipe the remaining fan parts. Do not allow water or any other liquid to get into the motor
housing or base. Reassemble fan after grilles and blade have dried completely. Do not plug
fan into electrical outlet until it has been fully reassembled.