Intended Use - Continental Electric CE27616 User Manual

INTENDED USE

This product is intended only for indoor residential and office use; and is not intended for
industrial or other commercial use. Use your fan only with adequate wiring that is to the elec-
trical code in your state. If you have any questions about the adequacy of your wiring, consult
a qualified electrician.
IMPORTANT OPERATING INSTRUCTIONS.
When using electrical appliances, basic safety precautions should always be taken including
the following:
Use the fan only for purposes described in the instruction manual. To protect against electrical
shock, do not immerse the fan plug or main cable in water or spay with liquids. Close supervi-
sion is necessary when any appliance is used by or near children. Unplug from the electrical
outlet when not in use, when moving the fan from one location to another, before putting on or
taking off parts and before cleaning. Avoid contact with any moving parts. Do not place the fan
or any parts near an open flame, cooking or other heating appliance. Do not operate any ap-
pliance with a damaged cord or plug or after the appliance malfunctions or has been dropped
damaged in any manner. The use of appliance cord is not recommended or sold by the appli-
ance manufacturer to be used separately from the fan and may cause hazardous situations if
used apart or on other appliances. Do not let the power cord hang over the edge of a table or
counter or come into contact with hot surfaces. To disconnect from the electrical supply, grip
the plug and pull from the wall outlet. Do not pull on the cord only to remove from wall outlet
or damage could occur. Always use fan on a dry, level surface. Do not operate without the fan
grilles properly in place.
This product is intended for household use only and not for commercial or industrial applica-
tions.
Should the appliance stop working, first check the fuse in the plug or fuse/circuit breaker in the
home/office, before contacting the manufacturer or service agent. If the supply cord or plug
is damaged, it must be replaced by the manufacturer or the service agent to avoid a hazard.
The appliance contains no user serviceable parts and should the product suffer damage or
breakdown it must be returned to the manufacturer or service agent. Do not use outdoors. Do
not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings.
Arrange cord away from traffic area and where it will not be tripped over.
ASSEMBLY INSTRUCTIONS
Tools required: Wrench or pliers and a Phillips head screw driver (not included).
Please assemble fan according to the illustration diagram.
CAUTION: NEVER REMOVE THE HICH HOLDS THE FAN HEAD IN PLACE.
1. Unscrew the plastic collar from the shaft en e motor housing by turning the collar COUN-
TER CLOCKWISE.
2. Remove the Rear Grill Mounting Nut. Place the Rear Grill onto the Motor Housing, make
sure the Handle on the Rear Grill is up.
3. Tighten the Rear Grill Mounting Nut CLOCKWISE. Secure the rear grill to the motor housing
with the plastic collar.
4. Insert the blade onto the motor shaft, matching the slot on the back of the blade with the
shaft pin, secure blade with blade cap, turning COUNTER·CLOCKWISE to tighten.
5. Test blade operation by rotating it with your hand. There should be no friction with the plastic
collar. If blade does not rotate freely, repeat Step 4.
6. Mount the front grill to the rear grill by positioning the clips on the front grill over the rear grill.
Secure the two grills with the clips attached to the rear grill.
7. Screw the wall Hang Hook on the desired wall firmly.
8. Attach the wall fan on the Hang Hook, making sure it is securely mounted before operation
CAUTION: To avoid the risk, make sure the Front and Rear Grilles are at
tached properly before operating.