Dimmer Control - Emerson Research CKS2862 Owner's Manual

Sleep To Music Timer
You can program the Sleep Timer to play the radio for up to 90 minutes and then
shut off automatically.
1.) Press the SLEEP button. The display will
briefly show "10" and the radio will begin
to play.
After 10 minutes the radio will shut off automatically. Each time you press the
SLEEP button the Sleep Timer will start at 10 minutes. This is the Sleep Timer
default setting.
2.) To increase or decrease the amount of time that the radio will play before
shutting off, hold the SLEEP button and press either the SET
SET (Down) button to change the display to the desired Sleep Time, up to a
maximum of 90 minutes or a minimum of 2 minutes.
Note: When you change the Sleep Timer from the 10 minute default setting
to a different setting, the new setting becomes the default setting. Whenever
you activate the Sleep Timer it will begin with your new default setting and
count down to zero from that point.
3.) To cancel the Sleep Timer before it counts down to "00" and shut the radio ' Off'
immediately, press the SNOOZE Bar.
IMPORTANT: Remember that the station and volume settings you choose for
the Sleep To Music operation are the same settings you will hear if you set the
alarm for Wake To Radio the following morning.

Dimmer Control

The DIMMER control was set to the HI (High) position at our factory.
If you find the clock display is too bright in a darkened room, set the DIMMER
control to the LO (Low) position.
CKS2862_061207.p65
16
16
(Up) or
12/6/2007, 15:54