Connecting Power Supply; Turning On The Power - Hitachi ED-AW100N User Manual

Connecting power supply

1.
Put the connector of the power cord into the
AC IN (AC inlet) of the projector.
2.
outlet. In a couple of seconds after the power
supply connection, the POWER indicator will
light up in steady orange.
power supply make the projector turn on.
WARNING
your dealer to get a new one.
cord. The power outlet should be close to the projector and easily accessible.
Remove the power cord for complete separation.

Turning on the power

1.
and correctly connected to the projector
and the outlet.
2. Make sure that the POWER indicator is
steady orange.
3.
lens door hits while opening. Press the
STANDBY/ON button on the projector or
the remote control. The lens door opens, the
projection lamp lights up, and the POWER
indicator begins to blink green. When the
power is completely on, the indicator will stop blinking and light in steady green.
WARNING
the projection lamp lights, since the projection lamp ray may cause
a trouble on your eyes.
Do not place the projector vertically with the lens door open as
NOTE
Please use extra caution when connecting the power cord, as
Never look into the projection lens or mirror while
STANDBY/ON button
POWER indicator
12
Power cord
AC IN
MY SOURCE/
VIDEO COMPUTER DOC.CAMERA
ASPECT AUTO SEARCH BLANK
MAGNIFY FREEZE PAGE VOLUME
UP
ON
DOWN
OFF
KEYSTONE
MY BUTTON MUTE
1 2
POSITION MENU
ENTER
ESC RESET