Table of Contents
Advertisement
Chapter 1 Installation
Unpacking
Before unpacking the LCD Monitor, prepare a suitable workspace for your Monitor and
computer. You need a stable and clean surface near a wall power outlet. Make sure that
the LCD Monitor has enough space around it for sufficient airflow. Though the LCD
Monitor uses very little power, some ventilation is needed to ensure that the Monitor
does not become too hot.
After you unpack the LCD Monitor, make sure that the following items were included in
the box:
* LCD Monitor
* 1.8M Monitor-to-PC DVI-D Cable
* User's Manual
If you find that any of these items is missing or appears damaged, contact your dealer
immediately.
Viewing Angle Adjustment
The LCD Monitor is designed to allow the users to
have a comfortable viewing angle. The viewing
angle can be adjusted as follows: Top (-5°~ +30°).
WARNING
Do not force the LCD Monitor over the maximum viewing angle settings as stated above.
In such an event, you will damage the Monitor and a Monitor stand.
Connecting the Display to your Computer
1.
Power off your computer.
2.
Connect one end of the signal cable
to the LCD Monitor's VGA port or DVI
port. (See Fig. 1-2)
3.
Connect the other end of the signal
cable to the VGA port or DVI port on your
PC.
4.
Make sure both connections are
secure.
ATTENTION
This device must be connected to an off-the-shelf video cable in order to comply with
FCC regulations. A ferrite-loaded interface cable is included in the LCD Monitor package.
This device will not be in compliance with FCC regulations when a non-ferrite-core video
cable is used.
* 1.8M Monitor-to-PC VGA Cable
* 1.8M Power Cord
Figure 1-2
Figure 1-1
13
Advertisement
Table of Contents
