Table of Contents
Advertisement
H (Horizontal) Position
This item shifts the image horizontally to right hand
side or left hand side of the screen.
• Select H Position item by using
• Use
/
button to adjust the value.
V (Vertical) Position
This item shifts the image vertically towards the top or
bottom of the screen.
• Select V Position item by using
• Use
/
button to adjust the value.
Phase
Depending on the resolution and scan frequency that
you input to the TV Set, you may see a hazy or noisy
picture on the screen. In such a case you can use
this item to get a clear picture by trial and error method.
• Use
/
button to adjust the value.
Dot Clock
Dot Clock adjustments correct interference that ap-
pear as vertical banding in dot intensive presenta-
tions like spreadsheets or paragraphs or text in smaller
fonts.
• Use
/
button to adjust the value.
Sound in PC mode
• Connect the PC's Audio output to the TV's PC Audio
In socket with an audio cable.
/
button.
/
button.
GB - 28 -
Other Features
TV Status
Programme Number,
Sound Indicator and Zoom Mode are displayed
on the screen when a new programme is entered.
Mute Indicator
It is placed in the upper side of the screen when
enabled.
To cancel mute, there are two alternatives; the first
one is pressing the
increasing the volume level.
PIP and PAP Modes
PIP picture is displayed on the screen by pressing
button . At PIP Mode, a small picture (PIP picture)
is displayed in the main picture.
When PIP Mode is entered, the default active window
is PIP window and the active window is indicated by
a red frame around it. The active window can be
changed by pressing
PIP position can be changed by pressing
tons.
When
button is pressed again, the TV switches
to PAP mode. In PAP Mode, two pictures with equal
sizes are displayed on the screen. Aspect Ratios of
the windows are fixed.
When you switch to PAP Mode, main window in PAP
Mode is displayed on the right side of the screen. The
active window can be changed by pressing
button.
Press the
button again to exit the PAP mode.
Note: When main picture source is TV, AV-1, AV-2,
AV-3 or AV-4; PAP or PIP window can only be
set to HDMI-1, HDMI-2, YPBPR, PC source or
vice versa.
AV Modes
You can switch your TV to AV modes by using re-
lated buttons on the remote control.
button till INPUT OSD is displayed
First, press
on the screen. You can then use; AV1, AV2, AV3,
AV4, AV5, HDMI1 or HDMI2 buttons on your remote
control to select the desired source (except being in
teletext).
Note that in PIP/PAP modes, pressing
will directly change sources.
Programme Name,
Mute
button and the second one is
/
buttons.
/
but-
/
button
Advertisement
Table of Contents
