Chicago Electric 66615 Set Up And Operating Instructions Manual page 13

11. Allow sufficient time for the polishing
liquid or wax to dry on the object.
To Polish an Object:
1. Attach the Polishing Bonnet (52) to
the Mounting Disc (51) as previously
discussed in this manual.
(See Figures a and B.)
2. Plug the Power Cord (5) into the nearest
120 volt, grounded, electrical outlet.
3. In order to keep the Power Cord (5) out
of the way, hang it over your shoulder.
IMPORTaNT: Start and stop the Polisher only
while it is held firmly against the surface
of the object being polished. Failure to
do so may result in the Polishing Bonnet
(52) being thrown from the Mounting
Disc (51).
4. Grip the Polisher firmly with both hands.
Then turn the Power Switch (11) to its
"ON" position. (See Figure C.)
5. Increase the tool's speed by pressing
the + Speed Button (13). Decrease the
tool's speed by pressing the – Speed
Button (13). (See Figure C.)
6. The Display (10) will indicate the tool's
speed.
7. Begin polishing the object by lightly
buffing off the polishing liquid or wax
residue in broad sweeping strokes in a
figure eight pattern. Continue polishing
until all the residue is removed.
IMPORTaNT: Apply minimal pressure on the
Polisher to avoid damaging the surface
of the object.
8. After the polishing liquid or wax has
been removed from the object's surface,
slide the Power Switch (11) to its "OFF"
position. Then unplug the Power Cord
(5). (See Figure C.)
SKU 66615 For technical questions, please call 1-800-444-3353.
9. Remove the Polishing Bonnet (52)
from the Mounting Disc (51). With the
Polishing Bonnet in your hand, remove
the polishing liquid or wax from all hard
to reach areas of the object.
(See Figures a and B.)
To Sand an Object:
1. Attach the Sanding Disc (54) to the
Mounting Disc (51) as previously
discussed in this manual.
(See Figures a and B.)
2. Plug the Power Cord (5) into the nearest
120 volt, grounded, electrical outlet.
3. In order to keep the Power Cord (5) out
of the way, hang it over your shoulder.
4. Grip the Polisher firmly with both hands.
Then turn the Power Switch (11) to its
"ON" position. (See Figure C.)
5. Increase the tool's speed by pressing
the + Speed Button (13). Decrease the
tool's speed by pressing the – Speed
Button (13). (See Figure C.)
6. The Display (10) will indicate the tool's
speed.
7. Once the Sanding Disc (54) is turning
at the desired speed, sand the object
evenly with gentle, broad, sweeping
strokes in a criss-cross pattern.
8. During the sanding process, it may
be necessary to occasionally stop the
Polisher, disconnect it from its electrical
outlet, remove the worn sandpaper and
replace with new sandpaper.
9. When the sanding process is complete,
turn the Power Switch (11) to its "OFF"
position. Then unplug the Power Cord
(5). (See Figure C.)
Page 13