Hitachi L200 Engineering Note page 2

7. Using the DN arrow key, change the value to
point after the number - this is critical!!) As you decrement the parameter
value, you will scroll past
going down toward zero, and the sequence will start again at
(WITH decimal point after!) and continue decrementing from there.
8. Continue down until the display reaches
value. The display should show
9. Navigate with the DN arrow key to
10. Change setting from
again to save. Display again should read
11. Press FUNC TWICE until display reads
12. Press UP arrow key until you reach
13. Press FUNC, then STR This step re-establishes the output frequency
display as the power-on default display.
The analog voltage input should now operate linearly with a 0 – 10 V input
corresponding to a 0 – 60 Hz output.
PGC - 2/2/05
1 1 0 0
(WITHOUT a decimal point!!) Continue
C 1 2 1
again.
C 0 9 1
0 1 0 0
back to with DN arrow key. Press STR
0 0 1
o
1 1 0 0 .
(Note the decimal
1 1 0 0 .
Press STR to save the
and press FUNC again.
C 0 9 1
C---
9 9 9 9 .
Page 2 of 2