Advertisement
audio output (RCA)
These sockets can be
used to connect to
external amplifier or Hi-
Fi system.
RF aerial socket
This should be
permanently connected to
an RF source - i.e your
aerial antenna.
Mains Socket
This should be
connected to the Mains
Supply via the supplied
Mains Lead.
SubWoofer
This socket can be
used to connect a
SubWoofer speaker.*
*If this product is used with an active SubWoofer, it is possible to change its frequency by
adjusting the LPF (Low Pass Filter) control on the Subwoofer speaker. This will enable you to
important note on installation
If you intend placing this TV into a cabinet or wall alcove, please ensure there is
at least a 100mm (10cm) gap to the sides, rear and top of the television. This is to
Do not allow soft furnishings, such as curtains to be draped over the TV whilst in
Never place the TV onto a carpet during normal operation - this could obstruct
Always place the TV on a flat surface, or if supplied, the stand accessory.
Failure to observe the above guidelines could result in serious overheating of your TV, or
VGA input
Use this to connect to
your computer if
desired.
AV4 scart input
Use this to connect
digital video
broadcasting equipment,
home entertainment
systems and DVD
players etc. to your TV.
Output sockets (SVHS monitor out & video out)
These sockets can be used to connect to external equipment to
supply a picture only, (no menus or Text), e.g. to a video projector.
PLASMA SCREEN
Link Socket
This should be
connected to your
AVC Unit via the link
lead.
select the most suitable sound performance.
allow for adequate ventilation.
ventilation slots on the base of the TV.
even, in extreme cases, fire.
Link Socket
This should be
connected to your
plasma screen via
the link lead.
AV2 scart input
Use this to connect
digital video
broadcasting
equipment and home
entertainment
systems to your TV.
test button
Use this button if you wish to test the
functionality of the plasma screen without the
AVC unit being attached. Press and hold this
button for more than 5 seconds and a test
picture will be displayed on the screen.
operation.
Mains Socket
This should be
connected to the Mains
Supply via the supplied
Mains Lead.
AUDIO
VISUAL
CONTROL
(AVC) UNIT
AV1 scart input
Use this socket to
connect ordinary VHS,
S-VHS or Hi8
equipment to your TV.
(Connect VCR to AV1
for Viewlink).
7
Advertisement
