Troubleshooting; Specifications - Elta 6733 Instruction Manual

TROUBLESHOOTING

If you experience any problem with this system, review the list below before you contact the
customer service.
WARNING: Never open the device. Always refer service or maintenance to authorized
customer service personnel.
PROBLEM POSSIBLE CAUSE
GENERAL
No sound Volume is set too low.
Earphones are connected.
Batteries exhausted.
Batteries inserted incorrectly.
Mains cable not connected.
RADIO
Poor reception Weak signal.
Interferences by other
appliances (TV sets, VCRs,
computers, etc.).
TAPE RECORDER
Poor sound quality Head, capstan or pinch rollers
dirty.
Recording does not work Tab in cassette broken out.
CD / MP3
CD skips CD / MP3 dirty or damaged.
Display: NO No CD inserted.
CD is dirty or damaged.
Condensation in laser lens.
CD-R / RW is empty or not
finalized.
28.
SOLUTION
Adjust the volume.
Disconnect the earphones.
Change the batteries.
Observe polarity.
Connect mains cable correctly.
Adjust antenna:
FM: telescopic antenna.
AM: adjust unit.
Keep distance to other
appliances.
Clean head, capstan and pinch
rollers.
Cover with cello tape.
Replace or clean the disc.
Insert a CD, CD-R or CD-RW.
Replace or clean the CD.
Wait until the laser lens is
completely dry (approx. 1 hour).
Finalize the CD-R / RW.

SPECIFICATIONS

General
Power Supply: AC 230V ~ 50Hz
DC 12V
(Batteries not included)
Frequency range: AM (MW) 525 - 1615kHz.
FM (UKW) 87.5 - 108MHz.
Audio
Speaker Impedance: .8 Ohm
Dimensions: ca. 290 x 275 x 380 mm
Weight: ca. 2 kg
SUBJECT TO CHANGE WITHOUT PRIOR NOTICE.
(6 Batteries Type LR14 / UM-2 / C, 1.5V)
29.