Related Manuals for FLI UNDERGROUND FU10A
Summary of Contents for FLI UNDERGROUND FU10A
- Page 1 UNDERGROUND INSTRUCTION & INSTALLATION MANUAL active enclosure MODEL: FU10A, FU12A, FU12TA...
- Page 2 Thank you for purchasing this FLI UNDERGROUND subwoofer enclosure. It will provide you with years of trouble free usage providing you follow a few simple guidelines. INTRODUCTION This instruction manual is for your safety and must be adhered to at all times. Please read and ensure that you fully understand the installation and set up procedures as explained.
-
Page 3: Run-In Procedure
Run in procedure FLI recommends that you follow the run in procedure for the subwoofer detailed below. When your subwoofer is used for the fi rst time naturally like most brand new items it is very stiff and rigid, it will take time for the moving parts of this subwoofer to loosen up before it will be ready to deliver its full potential. -
Page 4: Power Cable
Active enclosure Installation Your FLI UNDERGROUND enclosure is designed with a swift installation routine in mind. Please mount the enclosure in a dry location on a solid surface. NEVER mount the enclosure upside down, this will cause the amplifi er to overheat and will eventually damage the amplifi... -
Page 5: Ground Cable
ground cable • The ground cable needs to carry the same current as the power cable. At least a 10 gauge cable should be used. • The amplifi er ground should be connected directly to the chassis of the vehicle, to bare metal. - Page 6 AMPLIFIER CONNECTIONS & CONTROLS A. LOW LEVEL INPUT Low level input for connection to any source (headunit) with a low level output. This is your RCA output from the source (headunit). B. HIGH LEVEL INPUT To be used when no RCA’s are available. Use the provided loom to connect to the closest speakers. C.
-
Page 7: Set Up Section
Set Up Section To correctly set the gain control of the amplifi er to match that of the source (headunit) use the following setup routine: • Turn the gain control to minimum on the amplifi er. • Ensure the bass boost is set to 0 dB. •... - Page 8 System Wiring Input connections Connect to chassis / ground FUSE of vehicle Connect to remote turn-on lead of source unit BATTERY SOURCE (HEAD UNIT)
-
Page 9: Troubleshooting
Troubleshooting Before removing the amplifi er, refer to the list below and follow the suggested procedure. Always test the speakers and confi rm that they are wired correctly fi rst. If in any doubt get help from a qualifi ed auto electrician. AMPLIFIER WILL NOT POWER UP •... -
Page 10: Specifications
specifications Model FU10A FU12A FU12TA Driver FU10 FU12 FU12 x 2 Amplifier FU150.1 FU150.1 FU300.1 RMS power 250 watts 300 watts 600 watts Peak power 800 watts 1000 watts 2000 watts Impedance 4Ω 4Ω 4Ω Height 12.5” (317mm) 13.7” (347mm) 13.7”... -
Page 11: Limited Warranty
All content included in this manual such as text, graphics, logos, icons, images data, the selection and arrangement thereof, are the property of FLI Audio (herein referred to as “FLI”, “us” or “we”) and its affi liate or their content and technology providers, and are protected by United Kingdom and International copyright laws. - Page 12 AVAILABLE NOW IN THE FLI UNDERGROUND RANGE: UNDERGROUND up to up to speakers 270 watts 270 watts FU 4 FU 5 FU 6 FU 69 FU 5c FU 6c up to up to subwoofers 1200 watts 1200 watts FU 10 FU 12 FU 15 up to...