Panasonic CF-W4HWEZZBM Service Manual page 21

Is Acrobat Reader installed?
If Acrobat Reader is not installed, run the following*
program. When installing the program, do not change the installation destination folder .
If the destination folder is changed, the Reference Manual cannot be opened from [start]*
menu.
1
* English : [c:\util\reader\m\acroreader51_enu_full.exe]
Traditional Chinese : [c:\util\reader\tc\acroreader51_cht_full.exe]
Simplified Chinese : [c:\util\reader\sc\acroreader51_chs_full.exe]
Windows logon user name and password are not set in the SD memory card correctly.
Enter the Windows user name and password without using the SD memory card.
After logging on, reset the SD memory card, or use the [Control Panel] to create a user
with the user name and password set on the SD memory card.
If you change the setting for Language for non-Unicode programs after the check mark has
been added in [Use when logging on to Windows] under [SD Card Settings] - [Setting for
this SD card], remove the check mark from [Use when logging on to Windows] under [SD
Card Settings] - [Setting for this SD card], and set the user name and password again.
When using the SD memory card with other peripheral devices, format the SD memory
card using the peripheral device. For details, refer to the instruction manual for that device.
Note that the SD memory card is not supported by formats other than the SD memory
card standard.
When switching to a different user with the Fast User Switching function, the following
problems may occur.
• Some applications may not work properly.
• Key combination with
• It may not be possible to set the settings of the display.
• The wireless LAN cannot be used.
• The B' s CLiP icon will no longer be shown on the taskbar and a CD-RW disc cannot be
written on.
In this case, log off all users, and try the operation once more. If the problem persists,
restart the computer.
Is the disc bent or labeled?
Check to see if the disc is inserted correctly, and check that the disc is in good condition.
If the disc is good and inserted correctly , set [DVD Drive Speed] to [Low] in the Setup
Utility.
Press + +
which is not responding.
After shutting down by sliding the power switch for more than four seconds, slide the
power switch to power on and open the application again.
If the program no longer works normall, delete the program using the following menu.
Then reinstall the program.
: [start] - [Control Panel] - [Add or Remove Programs]
1
in [start] - [Run] to reinstall the
may not work.
to open Task Manager and close the software application
21
2