Connecting To Slimserver; Using The Remote - Logitech Squeezebox Owner's Manual

8
to your wireless access point, you can press the
your settings. If you are still having trouble, check the Troubleshooting section at
the end of this guide.
7. Choose whether you want the Squeezebox to obtain an IP address automatically
using DHCP, or whether you want to assign it a static IP address. Most networks
will let Squeezebox obtain an address automatically. Press the
If you chose to assign Squeezebox a static IP, enter it using the numbers on the
remote. Press the
Tip: Use leading zeroes to specify numbers with fewer than 3 digits, for example,
you would enter 00.00.00.8 for 0...8.
Enter the subnet mask for the network, the default gateway IP address, and the
address of your DNS server, pressing the
each one.

Connecting to SlimServer

. If SlimServer isn't already running, start it now.
Squeezebox will scan your local network to find the computer that's running
SlimServer. If you started SlimServer after configuring Squeezebox, you may need
to scroll to find it.
. Select the computer you want to use. If you are running SlimServer on multiple
computers on your local network, you can use the
one you want to use.
3. Press the
Setup is complete.
Tip: If you want to go back to setup later press the
down and hold it for five seconds. Squeezebox will return to the Set Up
Networking menu.

Using the Remote

Press to put Squeezebox into standby mode. This will dim the display, stop the
pOWER
music and show a clock. Press
arrow to save the address.
RIGHT
arrow on the remote to connect.
RIGHT
pOWER
LEFT
arrow on the remote to move to
RIGHT
LEFT
again to wake Squeezebox.
arrow to go back and fix
arrow.
RIGHT
arrow to scroll to the
dOWN
arrow on the remote
Logitech®