Lightolier IS:6706 Instruction Sheet

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE
This fixture is intended for installation in accordance with the National Electrical Code and local
regulations. To assure full compliance with local codes and regulations, check with your local electrical
inspectorbefore installation. To prevent electric shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
INSTRUCTIONS FOR INSTALLATION OF DISCUS SURFACE MOUNT FIXTURES
Note: This instruction sheet covers several fixture styles.
Ceiling pan, assembly, lamp type, and diffuser may vary
from that shown, although installation is the same.
INSTALLATION (FIG. 1):
WARNING: (RISK OF FIRE) SUPPLY WIRING MUST BE RATED
90˚ C. FOR CEILING INSTALLATION OF MODELS
6700MS213N1 & 6706MS213N1 ONLY. MOST DWELLINGS
BUILT BEFORE 1985 HAVE SUPPLY WIRE RATED FOR 60˚ C.
CONSULT A QUALIFIED ELECTRICIAN BEFORE INSTALL
1. Make sure that power to OUTLET BOX is off.
2. Partially thread MOUNTING SCREWS supplied into
OUTLET BOX.
3. While supporting CEILING PAN make electrical connections:
black fixture lead to hot (black) supply lead; white
fixture lead to neutral (white) supply lead. Uninsulated
fixture wire is a ground wire and must be connected
to grounding terminal or ground lead inside OUTLET BOX.
Green fixture wire(s) must also be connected to
grounding terminal or ground lead inside OUTLET BOX.
Use WIRE NUTS (local hardware item). Push supply wires
and connections back into OUTLET BOX.
4. Position CEILING PAN over MOUNTING SCREWS and allow
head of MOUNTING SCREWS to come through KEYHOLE
SLOTS in CEILING PAN. Slide CEILING PAN until MOUNTING
SCREWS are fully engaged in narrow portion of KEYHOLE
SLOTS and secure in place by tightening MOUNTING SCREWS.
5. Install recommended lamp(s).
CAUTION: USE ONLY LAMP WATTAGE AND
TYPE MARKED ON FIXTURE.
6. Align DIFFUSER NOTCHES with DIFFUSER BRACKETS on
CEILING PAN. Gently push DIFFUSER upward against
CEILING PAN and rotate clockwise until DIFFUSER is
(FIG. 2):
locked in position.
7. To remove DIFFUSER, rotate counterclockwise until
DIFFUSER NOTCHES pass over DIFFUSER BRACKETS.
INSTRUCTION SHEET NO.
IS:6706
A0200
SLIDE
FIG. 1
UN-LOCK
FIG. 2
LIGHTOLIER a GENLYTE THOMAS company.
631 Airport Road, Fall River, MA 02720
Page 1 of 1
OUTLET BOX
WIRE NUTS
MOUNTING
SCREWS
CEILING PAN
DIFFUSER
BRACKETS
KEYHOLE SLOT
DIFFUSER
OUTLET BOX
CEILING PAN
DIFFUSER
BRACKETS
DIFFUSER
NOTCHES
DIFFUSER
LOCK