Chapter 5 Downloading The Manual; Chapter 6 Performing A Scan Test - Fujitsu ScanSnap fi-6010N iScanner Getting Started Manual

Downloading the Manual
Chapter 5
In addition to this "Getting Started" guide, a "Operator's
Guide" is also available.
The "Operator's Guide" contains information about
scanner settings, scanner administration, and scanner
operations.
Consult this manual when using the scanner.
The "Operator's Guide" is a PDF file, and can be viewed
with Adobe® Reader® (*).
* Adobe® Reader® can be downloaded from the fol-
lowing site.
http://www.adobe.com/
Login as the administrator via the network interface to
download the "Operator's Guide".
The download procedure is as follows:
1. From the [Start] menu, point to [All Programs] -
[fi-scanner V2.1], and then click [fi Network
Scanner Admin Tool].
D The Admin Tool is started.
2. Specify the "Connect to" (of the scanner).
Enter the IP address, scanner name, or FQDN
name for the scanner to be setup or managed.
z If the port number was changed in
ATTENTION
"3.6 Setting the Admin Network"
(page 8) enter the changed port
number for "Port Number".
z When trying to connect with a port
number other than the specified
number, it will take up to 20 sec-
onds before a connection error
occurs.
z To use SSL, select the [Use
HTTPS] checkbox.
z If the Admin Tool is started while
there is insufficient free memory, a
script error may occur. Try again
after ensuring that there is enough
free memory.
3. Press the [Connect] button.
D The "Login" screen appears.
4. Press the [Download Manual] button.
D The "File Download" dialog box appears.
5. Press the [Save] button.
D The "Save As" dialog box appears.
When the [Download Manual] button
ATTENTION
is pressed, if Adobe® Reader® has
not been installed, and the [Open]
button on the "File Download" dialog
box is pressed, a "Connection error"
will occur.
6. Select a folder and enter a file name.
7. Press the [Save] button.
D The file is saved.
Next, perform a scan test.
13
Chapter 6 Performing a Scan Test
Perform a scan test to determine if the scanner is work-
ing properly. Login as a regular user to perform the scan
test.
1. Load the documents to be test scanned.
D The "Login" screen appears.
However, if the scanner is setup for automatic
login, the "Login" screen is not shown.
Proceed to Step 4.
2. On the "Login" screen, enter a "User Name"
and "Password".
Enter "guest" for the User Name and Password
fields.
3. Press the [Login] button.
D If the user name and password are valid, the
"Main Menu" screen appears.
4. Select the [Maintenance] button on the "Main
Menu" screen.
D The "Maintenance" screen appears.
5. Press the [Scan Test] button.
D The scan settings information for the scan test
is displayed.
6. Press the [Scan] button.
D Scanning starts. When the scan has completed,
the "Scan Viewer" opens.
14