Duerkopp Adler 467 Installation Instructions Manual page 21

6. Exiting the correction mode
-
Press the "P" key 2x.
7. Saving the setting
-
Briefly step forward on the pedal.
-
Step the pedal completely back.
Thread trimming occurs. The pressure feet rise.
The corrected setting is stored.
-
The sewing machine is ready for operation.
ATTENTION !
To complete the correction procedure it is essential to sew
a little. Only then is the changed setting finally stored.
If no sewing occurs the setting is lost when the main switch
is next turned off.
21