Duerkopp Adler N291 Installation Manual
Hide thumbs Also See for N291:

Advertisement

Contents:
Part 2: Installation manual Cl. N291
1.
General information . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2.
Assembling the machine stand . . . . . . . . . . . . . . . . . . . . . .
3.
Completing and screwing on the table top . . . . . . . . . . . . . . . .
4.
5.
fastening the pedal . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
6.
Fastening the handwheel and synchronizer . . . . . . . . . . . . . . .
7.
Connecting the maintenance unit . . . . . . . . . . . . . . . . . . . . .
8.
Laying and connecting the electrical cables . . . . . . . . . . . . . . .
9.
the mist lubricator . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Home
Page:
3
6
6
6
7
8
8
8
8
8

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the N291 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Duerkopp Adler N291

  • Page 1: Table Of Contents

    Home Contents: Page: Part 2: Installation manual Cl. N291 General information ......Assembling the machine stand .
  • Page 3: General Information

    1. General information Safety instructions 1.4 Parts of the sewing unit For your special attention! The sewing unit incorporates the The mains voltage and the following components: nominal voltage specified on Thread stand 1 the motor name plate must Machine head 2 be identical.
  • Page 5 700 79...
  • Page 6: Assembling The Machine Stand

    2. Assembling the stand 4. Connecting the sewing machine motor to the Assemble the stand parts as shown in the figure on page 2 and make sure that the table top stand rests on all 4 points. To do this, turn the screw at the machine stand (right- rear) accordingly.
  • Page 7: Mounting The Machine Head, Positioning The V-Belt And Fastening The Pedal

    4.2 Fastening the motor 5. Mounting the machine head, positioning the Screw the base of the motor to the table top. To do this, turn the 3 hexagon head V-belt and fastening cap screws M8 x 35 with the washers into the pedal the inserts of the table top.
  • Page 8: Fastening The Handwheel And Synchronizer

    Fastening the hand- 9. Filling in the oil and wheel a. synchronizer readying the machine for service To screw on the handwheel 4 proceed as follows: Pour the oil ESSO "SP NK 10" into the Turn the arm shaft until the timing pin 2 two reservoirs 1 and 7 up to the mark that is slid through the hole 3 in the "MAX".

Table of Contents