Switch Settings - Chamberlain RWA310R User Manual

Switch Settings

Antenna
PIR Sensor
Switch #1:.
OFF 6 m Detection Range
ON 12 m Detection Range
(Default)
Switch #2:
OFF Low Sensitivity
ON High Sensitivity
(Default)
Step 3
Insert battery pack facing away from circuit board and
attach cover.
NOTE: Ensure the batteries do not touch the circuit
board and the antenna and battery wires are not
pinched.
Step 4
Test PIR Motion Sensor by waving hand in front of
sensor. Test light should flash. Secure cover with the
smallest screws.
Switch #1
Test
Switch #2
Button
OFF
1 2 ON
Programming PIR Motion
Sensor to Base Station
Step 5
Plug in Base Station. Adhere
rubber pads to bottom. A
9-Volt battery (not provided) is
optional in case of power
failures.
Step 6
A
B
B Within 5 seconds, wave hand in front of PIR Motion
Sensor. Test light will illuminate and Base Station
will buzz.
2
OPTIONAL
A
B
A Ensure Base
Station and PIR
Motion Sensor are
in close proximity
to each other.
Press and release
learn button on
Base Station.
Buzzer will sound.