1. Manuals
  2. Brands
  3. EMP Tek Manuals
  4. Subwoofer
  5. E10s
  6. Owner's manual

EMP Tek E10s Owner's Manual

Hide thumbs Also See for E10s:
1
2
3
4
5
6
7
8
Table of Contents

Advertisement

Quick Links

Download this manual See also: Owner's Manual
POW ER ED SU BWOOFER
E10s
Model
S U B W O O F E R
OW N ER'S M A N UA L

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the E10s and is the answer not in the manual?

Questions and answers

Related Manuals for EMP Tek E10s

Summary of Contents for EMP Tek E10s

  • Page 1 POW ER ED SU BWOOFER E10s Model S U B W O O F E R OW N ER’S M A N UA L...

  • Page 2: Break-In Period

    Introduction Congratulations on your purchase of an EMP Tek E10s Powered Subwoofer! Your subwoofer is the result of many years of research and development dedicated to producing powerful, accurate bass in home audio systems. This manual contains operating procedures and specifications. We recommend you thoroughly read through the material contained in this manual before connecting your subwoofer.

  • Page 3: Care And Cleaning

    Subwoofers can add considerable low-frequency, deep bass performance to any home theater or audio system. At the heart of the EMP Tek E10s powered subwoofer is an aluminum cone driver. The driver material produces enhanced bass definition and accuracy. A powerful magnet, enhanced suspension and heavy duty voice coil give the driver elevated performance allowing high output capability and accurate dynamic reproduction.
  • Page 4 Setup Suggestions (continued) Placing the subwoofer away from walls will provide the least reinforcement, making the bass sound subjectively thinner than if the woofer were closer to a wall. Good results can usually be obtained by placing a subwoofer along a wall 1-3 feet from a corner.
  • Page 5 Amplifier Controls and Setup 1. Volume Control: The volume control should be at the minimum setting (all the way counter clockwise) before plugging the subwoofer into a 120V AC wall socket. 2. Crossover Frequency Control: The variable crossover frequency control allows you to set the crossover point of the subwoofer anywhere from 50-150 Hz.

  • Page 6: Specifications

    Amplifier fuse might be Replace fuse (if fuse is not readily blown. accessible, consult your autho- rized EMP Tek dealer). Performance is less The + and - polarity of the sub- Check the entire system for proper than expected woofer wire might be reversed polarity.

  • Page 7: Warranty

    Warranty Your EMP Tek E10s subwoofer is covered by a limited warranty against defects in materials and workmanship for a period of 5 (five) years on the woofer and cabinet, and 1 (one) year on the amplifier from the original date of purchase. This warranty is provided by the authorized EMP Tek dealer where the subwoofer was purchased.
  • Page 8 382 Marshall Way, Layton, Utah • USA • 84041 Toll Free: (800) 543-2205 • Fax: (801) 543-3300 www.emptek.com It is EMP Tek policy to continuously incorporate improvements into products; all specifications are subject to change without notice. Copyright © 2007 EMP Tek. All Rights Reserved.

Table of Contents