Replacing The Drive Sprocket - Compact Power BOXER 999-823 Operator's Manual

Replacing the Drive Sprocket

Overtime, the drive sprocket will wear, especially when used in sandy or clay soils. When this
happens, the digging chain will begin to slip. If the chain slips, replace the drive sprocket,
as follows:
1. Raise the trencher a few inches above the ground.
2. Stop the engine and remove the key.
3. Remove the spoils auger (Item 1,
4. Loosen the chain tensioning bolt lock nut (Item 14,
tensioning bolt (Item 13,
chain from the boom.
5. Remove the chain (Item 2,
removing the master link pivot pin. See Chain Master Link later in this section.
6. Remove and discard the old drive sprocket, making sure to keep the drive key (Item 3,
Figure 4–22).
7. Clean the sprocket mounting surface on the trencher.
8. Slide the new sprocket onto the drive shaft, align the key ways and insert the key locking the
sprocket to the shaft.
Inspect the trencher boom for signs of wear. If excessive wear is noted, flip the boom over or
replace it as needed. See Trencher Boom Replacement earlier in this section.
9. Loop the chain over the auger drive shaft and onto the drive sprocket, making sure that the
teeth point forward on the upper span.
Figure 4–22).
Figure 4–22) to loosen the trencher chain, until you can remove the
Figure 4–22) from the drive sprocket (Item 4,
NOTICE
Routine Service and Maintenance
Figure 4–22) and then rotate the chain
Figure 4–22) by
4-25