Download Print this page
Niles PERFORMANCE PR5 Installation & Operation Manual
Niles PERFORMANCE PR5 Installation & Operation Manual

Niles PERFORMANCE PR5 Installation & Operation Manual

Performance in-wall loudspeaker
Hide thumbs Also See for PERFORMANCE PR5:

Advertisement

I N S T A L L A T I O N & O P E R A T I O N G U I D E
M O D E L S
®
B
H
F
L E N D I N G
I G H
I D E L I T Y
A
®
A N D
R C H I T E C T U R E

Advertisement

loading
Need help?

Need help?

Do you have a question about the PERFORMANCE PR5 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Niles PERFORMANCE PR5

  • Page 1 I N S T A L L A T I O N & O P E R A T I O N G U I D E M O D E L S ® L E N D I N G I G H I D E L I T Y ®...
  • Page 2: Table Of Contents

    Systems Integration Amplifier are registered trademarks of Niles Audio Corporation. BumpBack and MicroPerf are trademarks without the diffraction distortion endemic of Niles Audio Corporation. Kaladex is a registered trademark of DuPont Teijin Films. Dolby is a registered trademark of Dolby to other speaker brands utilizing traditional Laboratories Licensing Corporation.
  • Page 3: Installation Considerations

    “clipping” The speaker baffle attaches to the frame, distortion. A large amplifier will play at the Niles makes a wide range of high perfor- and the grille mounts over the speaker. same volume without distorting. See the...
  • Page 4 “image”). In home theater applica- wire. For wiring runs longer than 80 feet 18 to 30 feet (6-10 meters) with any Niles tions where there is a center channel you In a home theater, the intelligibility of...
  • Page 5 “in the middle of your head” just sound of multiple speakers is to use mul- ary or a corner wall boundary. This can wired in mono! Consult your local Niles like headphones! tiple speakers. In large or unusually shaped make the speaker sound excessively dealer for more information.
  • Page 6: Installation Fundamentals

    In between the studs er in your walls, consult a Niles dealer or hum on your speaker wires, so you can and the joists is the space for the wiring...
  • Page 7 ing a penlight into the wall. building codes, some municipalities Figure 6 If you have access to an attic require conduit). or basement space you can In traditional wood stud/drywall construc- quickly see which part of the tion you can cut the hole for the speaker wall space is free of obstruc- and utilize the large hole to auger holes tions (See Figure 5).
  • Page 8: Installation Of Brackets, Frames And Grilles In New Construction

    Installation of Screw one side of the assembled bracket the grille with paint. The grille is construct- with wings to the stud using one of the ed of aluminum with a perfectly even Brackets, Frames supplied screws. Level the bracket. Screw powder coat overall.
  • Page 9: Installation Of Brackets, Frames And Grilles In Existing Walls

    4. If you are cutting into lath and plaster walls, use masking tape to outline your IMPORTANT: Before you cut into any Installing a Niles MS110 MicroSensor penciled marks, drill the four corners with There is a 1/2” round molded “IR Sensor wall, review the sections on running a 1/4”...
  • Page 10 1. Stand half way between the two speak- Installing the Speaker If the grille is already 6. Repeat these instructions ers. installed, remove it by for each speaker you are 2. Play some music with the amplifier or using a bent paper clip or connecting to the ampli- radio set to Mono.
  • Page 11: Operation

    Removal of Speaker Operation Adjusting the Tweeter The tweeter is housed in a precision adjust- ment mechanism which enables precise and Grille aiming of the directional high frequencies Listening at Higher Volumes to provide optimum performance. To adjust It requires more power to achieve a reason- able volume of sound in a large room than the tweeter: Removing The Speaker...
  • Page 12: Specifications

    Specifications Specifications Model PR5 Model PR6 Driver Complement Driver Complement 5-1/4” Talc-Filled Polypropylene Woofer 6-1/2” Talc-Filled Polypropylene Woofer with Custom Debris Screen and Butyl with Custom Debris Screen and Butyl Rubber Surround Rubber Surround 3/4” Kaladex ® Tweeter Housed in a 3/4”...
  • Page 13 Niles Audio Corporation 12331 S.W. 130 Street Miami, Florida 33186 Tel: (305) 238-4373 ©2008 Niles Audio Corporation. DS00279B Fax: (305) 238-0185 www.nilesaudio.com...

This manual is also suitable for:

Pr6