Installing Or Replacing A Hard Disk Drive Enablement Module - Lenovo ThinkStation C30 Hardware Maintenance Manual

Note: If you are installing a SAS hard disk drive, you need to connect the signal cable and power cable
to the SAS-to-SATA adapter and then connect the adapter to the SAS hard disk drive.
Figure 31. Connecting a SAS hard disk drive
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 127.

Installing or replacing a hard disk drive enablement module

Attention: Do not open your computer or attempt any repair before reading and understanding the "Important
Safety Information" on page 1.
This section provides instructions on how to install or replace a hard disk drive enablement module.
To install or replace a hard disk drive enablement module, do the following:
1. Turn off the computer and disconnect all power cords from electrical outlets.
2. Remove the computer cover. See "Removing the computer cover" on page 80.
3. Lay the computer on its side for easier access to the system board.
4. Remove the PCI card holder. See "Removing and reinstalling the PCI card holder" on page 81.
5. Remove the front fan assembly for easier access to the hard disk drive enablement module. See
"Replacing the front fan assembly" on page 93.
6. Locate the hard disk drive enablement module on the system board. See "Locating parts on the
system board" on page 76.
.
Chapter 10 Replacing FRUs
101