Sol/Ider/Kvm; User Consent - Lenovo ThinkCentre M92p Configuration Manual

Note: If you disable the Manageability Feature Selection function, all the network settings including ACLs
will be reset to factory default settings.

SOL/IDER/KVM

Select SOL/IDER/KVM in the INTEL(R) AMT CONFIGURATION window and press Enter. The SOL/IDER/KVM
window opens. The following options will be displayed.
Option
Username & Password
SOL
IDER
Legacy Redirection Mode
KVM

User Consent

The User Consent option specifies whether local user consent is required to establish a KVM remote control
session over a computer, and whether the user of the computer can configure the KVM Opt-In Policy.
If you press Enter, the following options will be displayed.
• User Opt-in
Used to specify whether user consent is required to establish a KVM remote control session over a
computer.
– When this option is set to None, local user consent is not required to establish a KVM remote control
session over a computer.
– When this option is set to KVM, local user consent is required to establish a KVM remote control
session over a computer.
– When this option is set to All, local user consent is required to establish an IDER, KVM, or SOL remote
control session over a computer.
12
ThinkCentre M92/p and M92z Intel Active Management TechnologyConfiguration Guide
Description
Used to enable or disable the username and password
for the SOL/IDER session. If the Kerberos network
authentication protocol is used, this option should be
set to DISABLED because the user authentication is
managed through Kerberos. If the Kerberos network
authentication protocol is not used, the IT administrator
can choose to enable or disable the username and
password for the SOL/IDER session.
Used to enable or disable SOL. If the client supports
SOL and SOL is enabled on the client, the Intel AMT
managed client input or output can be redirected to
the management server console. If the client does not
support SOL, the SOL option cannot be enabled.
Used to enable or disable IDE-R. If IDE-R is enabled, the
Intel AMT managed client can be booted from remote
disk images through a management server console. If the
client does not support IDE-R, the IDER option cannot
be enabled.
Used to enable or disable legacy redirection mode.
Legacy redirection mode controls how the redirection
works.
Attention: The default setting is DISABLED, which is
used for enterprise consoles and new Small and Medium
Businesses (SMB) consoles. If you are using a legacy
SMB Redirection Console, you must set the Legacy
Redirection Mode feature to ENABLED.
Used to enable or disable the KVM feature.