Demonstration; Volume Level Setting Of External Input (Aux Level); Changer Volume Level Setting (Chg Level); Xm Level Setting (Xm Level) - Alpine CRA-1667RF Owner's Manual

Demonstration

This unit has a Demonstration feature which simulates the
display functions.
1
Press and hold the SETUP button of the Remote
Display or the Remote Control for at least 2 seconds.
2
Turn the rotary encoder of the Remote Display to the
left or the right, or press the 8 or 9 button of the
Remote Control to select "DEMO".
3
Press the ( or ) button of the Remote Display or
the g or f button of the Remote Control to turn
on or off the DEMO mode.
If no button is pressed for 30 seconds, the DEMO
mode activates.
NOTES
• The initial setting at the factory is "DEMO ON."
• To quit DEMO mode, set to "DEMO OFF."
4
Press the SETUP button of the Remote Display or the
Remote Control again to return to normal operation.
Volume Level Setting of External
Input (AUX LEVEL)
When the volume of an external input that is output on
the head unit side is too loud or too small, set the level
between AUX LEVEL 1 and 4.
1
Press the 4 or 3 button of the Remote Display or the
8 or 9 button of the Remote Control to set the desired
volume level (AUX LEV 1 to 4).
NOTE
You can select AUX LEVEL only when AUX is on in "Setting the
AUX Mode (V-Link)," on page 6.
TIPS
You can set the volume level also from the SETUP mode.
1. Press the SETUP button of the Remote Display or the
Remote Control for at least 2 seconds.
2. Turn the rotary encoder of the Remote Display, or press the
8 or 9 button of the Remote Control to select "AUX LEV".
The level is displayed only when the AUX mode is "AUX
ON". (See the section of "Setting the AUX Mode" on Page 6.)
3. Press the ( or ) button of the Remote Display, or the
g or f button of the Remote Control to set the desired
volume level.
4. Press the SETUP button of the Remote Display or the
Remote Control to return to the Normal mode.
Changer Volume Level Setting
(CHG LEVEL)
When a changer is connected, and when the changer
volume output to the head unit side is too loud or too
small, set the volume between CHG LEVEL 1 and 4.
1
Press the SETUP button of the Remote Display or the
Remote Control for at least 2 seconds.
2
Turn the rotary encoder of the Remote Display, or
press the 8 or 9 button of the Remote Control to
select "CHG LEV".
NOTE
The level is displayed only when a changer is connected.
3
Press the ( or ) button of the Remote Display, or
the g or f button of the Remote Control to set
the desired volume level.
4
Press the SETUP button of the Remote Display or the
Remote Control to return to the Normal mode.

XM Level Setting (XM LEVEL)

When an XM receiver is connected, and when the XM
receiving volume output to the head unit side is too loud
or too small, set the volume between XM LEVEL 1 and 4.
1
Press the SETUP button of the Remote Display or the
Remote Control for at least 2 seconds.
2
Turn the rotary encoder of the Remote Display, or
press the 8 or 9 button of the Remote Control to
select "XM LEV".
NOTE
The level is displayed only when an XM receiver is connected.
3
Press the ( or ) button of the Remote Display, or
the g or f button of the Remote Control to set
the desired volume level.
4
Press the SETUP button of the Remote Display or the
Remote Control to return to the Normal mode.
7
-EN