Table of Contents
Advertisement
5. Positioning the Machine Head, V-belt Placement,
Attaching the Belt Guard and Handwheel
1
10
2
–
Set the sewing head into the table top cutout.
–
Fold over the sewing head and remove the
safety bar 1.
–
Plug the arresting pin 2 into one of the notches
of the built-in adjustment disc.
–
Screw off the handwheel.
–
First place the V-belt over the machine belt
pulley.
–
Place the belt on the motor belt pulley.
By swinging the motor tension the V-belt so
that it can be pressed in at its center by about
10 mm without great effort.
–
Screw on the belt guard with 5 screws.
When folding over, the belt guard must go into
the table top cutout unimpaired.
–
Screw on the motor belt guard.
Set the securing cams so that the belt does
not slip out of the belt pulley when the sewing
head is folded over.
–
Screw on the handwheel.
The correct position of the handwheel is
derived from the additional holes in the hand
wheel and on the belt flange. They must lie
congruent.
Advertisement
Table of Contents
