Door Position; Food Storage; Ambient Temperature/Cooling Unit/High Humidity; Interior Liner Seal To Frame - Dometic RM2310 Service Tips Manual

DOOR POSITION

To correct an alignment of the door, loosen the hinge screws slightly, and reorient the door in the proper position.
If the door needs more adjustment than is available through the hinge adjustment, the base can be repositioned to
reorient the door.
AMBIENT TEMPERATURE
As the ambient temperature increases, the air temperature in the area of the cooling unit increases.
COOLING UNIT
To check the cooling unit, first verify the AC heating element is good. Then place approximately one gallon of water
inside the refrigerator and place a thermometer in one of the containers of water. Supply 115 volts direct to the AC
heating element and operate for at least 12 hours. Check the temperature on the thermometer. It should be at 45
degrees or lower depending on test conditions.

FOOD STORAGE

Rearrange your foodstuffs. It is essential that the shelves are not covered with paper or large storage containers.
Always remember to allow for proper air circulation. Odorous or highly flavored foods should always be stored in
covered dishes, plastic bags or wrapped in foil or waxed paper to prevent food odors. Vegetables, lettuce, etc., should
be covered. NEVER PUT HOT FOOD INTO THE REFRIGERATOR.
HIGH HUMIDITY
High humidity may cause a small amount of condensation to form on the frame of the refrigerator. As the humidity is
reduced, the sweating will decrease.

INTERIOR LINER SEAL TO FRAME

There is a seal that is applied to the liner in the area where the metal frame makes contact with the interior liner. Cold
air can migrate out to the metal frame.
Clean the metal frame and foil-backed insulation around the refrigerator.
between outer frame and foil-backed refrigerator insulation. Make sure the refrigerator is dry and that the surface
temperatures are above 50°F. Use a clear silicon caulking compound and seal the seam between the refrigerator's
plastic liner and the metal frame. NOTE: TO FORM A PROPER SEAL, IT IS IMPORTANT NOT TO LEAVE ANY
GAPS.
a foil-backed adhesive tape to the joint
Apply
23
DOUBLE DOOR
REFRIGERATOR
SHOWN WITH
D O O R S R E -
MOVED