Avc 1800 Remote Control Buttons - Parasound AVC-1800 Owner's Manual

Reset Button Access Hole
This button restores all factory defaults and clears the programmed memory. Use a toothpick
or other small non-metal tool to access the reset button.
Volume Control
This knob adjusts the master volume up and down in 1 dB increments. The volume display
changes to show the current volume level.

AVC 1800 Remote Control Buttons

Device Buttons
The device buttons allow you to choose different "pages" to control up to six additional
components. Note: First press the AVC button to control the AVC-1800 and press the
Zone button to operate the remote zone.
Display
The Display button activates the on-screen display to show the operational status of the
AVC-1800. There are two levels of on-screen display. The first press of the button shows
input status, the second press of the button displays the channel levels and decoding status,
and the third press turns the display off.
Input Level Buttons
These buttons set the signal level to the analog input circuit to prevent overload. If the
overload LED illuminates, you need to turn the input level down. Press the Input button
to increase the level to the analog input circuitry. Press the Input button to decrease the
level to the analog circuitry.
Digital Button
The Digital button allows you select any of the four digital inputs or the analog input.
Surround Button
The Surround button allows you to cycle in either direction to select the Surround Processing
modes including Pro Logic, 5.1, and two channel stereo.
On and Off Buttons
Press the On button to turn the AVC-1800 on; press the Off button to turn it off. Separate on
and off commands for ease of use while setting up macros or programming external system
controllers. This operation is different for the remote zone.
Trim Button
Press and release the Trim button to temporarily trim the volume levels of individual channels
levels to suit your taste while listening to a particular film soundtrack or recording.
Volume Buttons
The Volume and buttons adjust the master volume up and down in 1 dB steps. These
buttons are also used for making adjustments during Trim and calibration (Cal) operations.
25