Fitting A Door Front Panel Made By Another Manufacturer; Preparing The Front Panel - Miele W 2839i WPM Operating Instructions Manual

Fitting a door front panel made
by another manufacturer

Preparing the front panel

Measure distance X for drilling the
hinge holes.
– with spacer bars:
– without spacer bars:
(the front panel must be
correspondingly higher)
Installation and connection
Mark the two hinge holes and the
four smaller holes as shown in the
diagram.
Depending on country this machine
is supplied either left or right hand
hinged.
For left hand hinging only:
– front panel shown decor side face
down, upper edge at the bottom:
if width (b) increases, measurement a
must also be increased
b = 592 mm N a = 21.5 mm
b = 593 mm N a = 22.0 mm
b = 594 mm N a = 22.5 mm
b = 595 mm N a = 23.0 mm
b = 596 mm N a = 23.5 mm
The height H of the door front panel
corresponds to the door height of the
adjacent units.
61