Electrolux EWG 14740 W User Manual page 42

42 electrolux 42 electrolux
Drill four fixing holes see Fig. G
Top view
Position the base into the recess with its
front edge as far forward as the adjoin-
ing plinth line will allow.
The reason for placing the base in
this position is to allow a small strip
of beading to be fitted in front of the
appliance feet.
Fix the base firmly to the floor using four
appropriate countersunk screws (see
Fig. H).
With the appliance installed adjust all
four feet ensuring the machine is stable,
and a clearance of approximately 5 mm
is left between the top of the machine
and the underside of the worktop.
A final check for stability should be car-
ried out with the machine on spin with a
load, this will identify the need for any
further fine adjustment to the feet.
A strip of beading approximately 605
mm W, x 5 mm H, x 25 mm D must be
screwed down into the base directly in
front of the machine's feet, this will pro-
vide additional security.
If required an additional door magnet,
part number 1242394-00/3 and disc,
part number 1242393-00/5 are avail-
able from spare parts.