AEG LAVAMAT 64810 User Information page 20

Problem
E10 appears.
The END indicator is
flashing once, and si-
multaneously an acous-
tic signal is sounding
once.
(Problems with the wa-
ter inflow.)
The washing machine
vibrates when operating
or is not stable.
Washing has not been
spun.
Water is running out
from under the washing
machine.
The wash water is
foaming a lot. At the
end of the wash cycle
the spinning stops.
E20 appears.
The END indicator is
flashing twice, and si-
multaneously an acous-
tic signal is sounding
twice.
(Problems with the wa-
ter outflow.)
20
Possible cause
The tap is shut off.
The filter in the inlet hose
screw connection is blocked.
The tap is blocked by limes-
cale or faulty.
The transit packaging has
not been removed.
The screw feet not correctly
adjusted.
Only a few large items of
washing in the drum.
The inlet hose screw con-
nection is leaking.
The outlet hose is leaking.
The drain pump lid has not
been closed properly.
Washing was caught in the
door.
The emergency drain hose is
leaking.
Probably too much deter-
gent has been used.
There is a kink in the outlet
hose.
The maximum pump height
of 1m has been exceeded.
The drain pipe is blocked.
For sink spigot connections:
The spigot is blocked.
Remedy
Turn on the tap.
Turn off the tap. Unscrew the
hose, remove the filter and
clean it.
Check the tap and have it re-
paired, if necessary.
Removing the transit pack-
aging.
Adjust the feet as described
in the installation and con-
nection instructions.
Always load the drum as full
as possible. Mix large and
small items.
Tighten the inlet hose.
Replace outlet hose.
Close the cover properly.
Load carefully next time you
wash.
Screw on the emergency
drain hose firmly.
Follow the manufacturer's
instructions exactly when
measuring out detergent.
Straighten the hose.
Please contact your local
Service Force Centre
Switch off the appliance.
Disconnect the power plug.
Clean the drain pump. Re-
move foreign bodies from
the pump housing.
Clean the spigot.