Alpine VPA-B222R Owner's Manual page 51

Mounting the Commander
For safe use, make sure of the following:
• Location is stable and film.
• Driver's view or operations are not obstructed.
• Located where driving can easily be performed (centre console, etc.).
During operation, ensure that your driving posture does not change,
or that your attention is not taken away from safely driving your
vehicle.
1
Confirm where the holder is to be placed, and
determine its direction.
The angle of the commander can be adjusted according to
the direction of the holder.
Pattern 1
Pattern 2
2
Route the commander connection cable through the
holder.
Pattern 1
Pattern 2
Route the cable through the
hole in the underside.
50
-EN
Route the cable through
the hole in the side.
3
Mount the Holder
• When the holder cannot be mounted securely with double-sided
adhesive tape, mount it by using screws.
Reinforcement screws
Protective
Paper
Console box, etc.
*Before attaching the tape, make sure the mounting location is free
from dust or dirt.
4
Connect the commander cable to the commander.
5
Take up any slack by pulling the cable, while holding
the holder.
6
Set the commander on the holder.
After aligning the 2 projections on the backside of the
commander with the groove of the holder, then turn the
commander clockwise until it clicks.
• When you remove the commander from the holder, turn the
commander counterclockwise by pressing
remove the commander.
WARNING
DO NOT INSTALL THE COMMANDER NEAR THE
PASSENGER AIR BAG.
If the unit is not installed correctly, the air bag may not function
correctly, and if the air bag is triggered, parts may spring
upwards and cause accident or injury.
7
Fix the connection cable with the supplied cable
clamp.
Commander
Holder
Double-sided
adhesive
tape*
Projections
on the holder, then