Connections To Other Equipment - Sansui HDTV3000 Owner's Manual

Connections to other equipment

The exact arrangement you use to interconnect various video and audio components to the TV is dependent on
the model and features of each component. Check the Owner's Manual provided with each component for the
location of video and audio inputs and outputs.
The connection diagrams below are offered as suggestions. You may need to modify them to accommodate
your particular assortment of components. The diagrams are intended to show component video and audio
interconnections only.
Selecting the video input source
Press TV/AV to view a signal from another device connected to your TV, such
as a VCR or DVD player. You can select ANT, VIDEO1, VIDEO2, VIDEO3 (on
the front panel), COMPONENT1, or COMPONENT2 depending on which
input jacks you used to connect your devices.
Pressing TV/AV on the remote control displays the current signal source
(press TV/AV again or 0-5 to change).
To connect the TV to a VCR
To connect the TV to a VCR with an S-Video cord
If you connect a VCR with a S-VIDEO cord to the S-VIDEO IN jack on the rear of the TV, you must also connect
the audio cords to the AUDIO IN jacks on the rear of the TV. The S-VIDEO cord only carries the video signal.
The audio signal is separate.
To Audio OUT
NOTE:
When the S-video cord and the video cord are connected to each jack at the
same time, the S-video cord takes precedence over the video cord.
10
To Audio/Video OUT
Audio/Video cord (not supplied)
To S-Video OUT
S-Video cord (not supplied)
Audio cord (not supplied)
To AUDIO/VIDEO IN 1 (or 2)
To S-VIDEO IN 1 (or 2)
To AUDIO IN 1 (or 2)
SOURCE SELECTION
0. ANT
1. VIDEO1
2. VIDEO2
3. VIDEO3
4. COMPONENT1
5. COMPONENT2
SELECT : /0-5
SET : ENTER
Rear of the TV
Rear of the TV