Chapter 5. Installing Or Replacing Hardware; Installing Or Replacing Hardware; Installing External Options; Removing And Reinstalling The System Stand Hinge Cover - Lenovo ThinkCentre Edge 92z User Manual

Chapter 5. Installing or replacing hardware

This chapter provides instructions on how to install or replace hardware for your computer.
Attention: To prevent possible damage to your computer, do not remove the computer cover and install or
replace internal parts by yourself. See Chapter 11 "Getting information, help, and service" on page 73 for
more information about help, service, and technical assistance for Lenovo products.

Installing or replacing hardware

This section provides instructions on how to install or replace hardware for your computer. You can expand
the capabilities of your computer and maintain your computer by installing or replacing hardware.
Attention: Do not open your computer or attempt any repair before reading and understanding the "Important
safety information" on page iii.
Notes:
1. Use only computer parts provided by Lenovo.
2. When installing or replacing an option, use the appropriate instructions in this section along with the
instructions that come with the option.

Installing external options

You can connect external options to your computer, such as external speakers, a printer, or a scanner. For
some external options, you must install additional software in addition to making the physical connection.
When installing an external option, see "Locating connectors, controls, and indicators on the front of your
computer" on page 7 and "Locating connectors on the rear of your computer" on page 9 to identify the
required connector. Then, use the instructions that come with the option to help you make the connection
and install any software or device drivers that are required for the option.

Removing and reinstalling the system stand hinge cover

Attention: Do not open your computer or attempt any repair before reading and understanding the "Important
safety information" on page iii.
This section provides instructions on how to remove and reinstall the system stand hinge cover.
CAUTION:
Turn off the computer and wait three to five minutes to let the computer cool before removing the
system stand hinge cover.
To remove and reinstall the system stand hinge cover, do the following:
1. Remove any media from the drives and turn off all attached devices and the computer.
2. Disconnect all power cords from electrical outlets.
3. Disconnect the power cords, Input/Output cables, and any other cables that are connected to the
computer. See "Locating connectors, controls, and indicators on the front of your computer" on page 7
and "Locating connectors on the rear of your computer" on page 9.
4. Place a soft, clean towel or cloth on the desk or surface. Hold the sides of your computer and gently lay
it down so that the screen is against the surface and the cover is facing up.
© Copyright Lenovo 2012 27