Installation; Front Panel Features; Top Panel Features - Cary Audio Design CAD-805 Anniversary Edition Setup And Operation Manual

Front Panel Features

CAT EYE TUBE: Indicates approximate power output level. When the eye is completely
closed the amplifier is at full power output.

Top Panel Features

OFF-ON TOGGLE SWITCH: Turns AC power on in the rear position. The output tube
STANDBY SWITCH:
TUBE SELECTOR SWITCH: Set either to 211 or 845 before installing selected output
FEEDBACK LEVEL:
Rear Apron Features
INPUT:
OUTPUT:
FUSE: AC power fuse. Never replace with any other value than 3 AMP
SLOW BLOW FUSE! 250 VOLT!
TUBE FUSE: Never replace with any other fuse than _ amp FAST BLOW
FUSE!

Installation

This section describes the unpacking and installation procedures for your new amplifier.
Unpacking
All shipping containers have been specially designed to protect their contents and special care
has been taken to prevent damage under normal shipping conditions. Mishandling should be
evident upon inspection of the shipping container. If shipping damage is found after visual
inspection, take care not to destroy the evidence. If necessary, document the damage with
photographs and contact the transport carrier immediately. Carefully remove your new CAD-
805 Anniversary Edition from its packing carton and examine it closely for signs of shipping
damage. It is recommended to save all original packing cartons and crates to protect your
amplifier from damage should you wish to store it or ship it for after-sales service.
will not light at this point.
Turns the filament of the output tube on in the rear
position.
tube.
Adjusts the level of feedback from 0 to 10 dB
Signal input connection via shielded RCA interconnect cable
Three 5-way binding posts provide output to the speaker
system (4, 8 or 16 ohm connections).
Page 3