Table of Contents
Advertisement
Daily use
Load the laundry
Measure out the detergent and the fabric softener
Pull out the dispenser drawer until it stops. Measure
out the amount of detergent required, pour it into the
main wash compartment
partment if the selected programme/option it requires
(see more details in "Detergent dispenser drawer").
If required, pour fabric softener into the compartment
marked
(the amount used must not exceed the
«MAX» mark in the drawer). Close the drawer gently.
Select the required programme by turning the
programme selector dial (1)
Turn the programme selector dial to the required pro-
gramme. The washing machine will automatically select
the maximum spin value provided for the programme you
have chosen. You can change this value by pressing the
corresponding button. The green pilot light of the button
6 starts to flash.
The selector dial can be turned either clockwise or coun-
terclockwise. Turn to position « O » to reset programme/
Switching the machine off.
At the end of the programme the selector dial must be
turned to position O, to switch the machine off.
Caution! If you turn the programme selector dial to
another programme when the machine is working,
Open the door by carefully
pulling the door handle
outwards. Place the laun-
dry in the drum, one item
at a time, shaking them out
as much as possible.
Close the door.
or in the appropriate com-
the red pilot light of button 6 will blink 3 times to indicate
a wrong selection. The machine will not perform the new
selected programme.
Select the required temperature by turning the
temperature selector dial (2)
Turn clockwise this dial to select the more convenient to
your laundry washing temperature.
Select the available options by pressing buttons 3,
4 and 5
Depending on the programme, different functions can be
combined. These must be selected after choosing the de-
sired programme and before starting the programme.
When these buttons are pressed, the corresponding pilot
lights illuminate. When they are pressed again, the pilot
lights go out. If an incorrect option is selected, the inte-
grated red pilot light of the button 6 flashes for 3 times.
For the compatibility among the washing pro-
grammes and the options see chapter «Washing
Programmes».
Start the programme by pressing button 6
To start the selected programme, press the button 6 , the
corresponding green pilot light stops blinking. The ap-
pliance starts operating and the only pilot light corre-
sponding to the running phase stays on.
To interrupt a programme which is running, press the
button 6 : the corresponding green pilot light starts blink-
ing.
To restart the programme from the point at which it was
interrupted, press the button 6 again .
If an incorrect option is selected, the red pilot light of the
button 6 blinks 3 times.
Altering an option or a running programme
It is possible to change some options before the pro-
gramme carries them out.
Before you make any change, you must PAUSE the ap-
pliance by pressing the button 6 .
Changing a running programme is possible only by re-
setting it. Turn the programme selector dial to O and then
to the new programme position. Start the new programme
by pressing the button 6 again. The washing water in the
tub will be not emptied out.
7
Hide quick links:
Advertisement
Table of Contents
