Table of Contents
Advertisement
6. Hardware Installation
Before installing the DIGI9652, please make sure the computer is switched off and the
power cable is disconnected from the mains supply. Inserting or removing a PCI card while
the computer is in operation can cause irreparable damage to both motherboard and card!
1. Disconnect the power cord and all other cables from the computer.
2. Remove the computer's housing. Further information on how to do this can be obtained
from your computer´s instruction manual.
3. Important: Before removing the DIGI9652 from its protective bag, discharge any static
in your body by touching the metal chassis of the PC.
4. Connect the DIGI9652 card with the Expansion Board using the supplied flat ribbon
cable. Note: The connectors on the cable cannot be plugged in the wrong way round.
5. Insert the DIGI9652 firmly into a free PCI slot, press and fasten the screw.
6. Insert the Expansion Board and fasten the screw.
7. Replace the computer's housing.
8. Reconnect all cables including the power cord.
Note: If neither word clock nor a third ADAT I/O is required, it is not necessary to install the
Expansion Board at all (i.e. leave out steps 4 and 6).
7. Driver Installation
7.1 Windows 98/SE/ME
After the hardware has been installed correctly (see 6. Hardware Installation), and the computer
has been switched on, Windows will recognize the new hardware component and start its 'Add
New Hardware Wizard'. Insert the RME Driver CD into your CD-ROM drive, and follow further
instructions which appear on your computer screen. The driver files are located in the directory
\Hammerfall W98 on the RME Driver CD.
Windows will install the DIGI9652 driver, and will register the card in the system as a new
audio device. The computer should now be re-booted.
Unfortunately, there are rare cases where the CD-ROM path (i.e. its drive-letter) has to be
typed in again during the copy process.
The Hammerfall is configured using the DIGI9652 driver's Settings dialog (see section 9.1)
7.2 Windows NT
As automatic hardware recognition has not been implemented in Windows NT 4.0 the drivers
have to be installed 'by hand'.
After the hardware has been installed correctly (see 6. Hardware Installation) and Windows NT
has been booted, insert the RME Driver CD into your CD-ROM drive. Register the new device
by starting >Control Panel /Multimedia /Devices /Audio Devices /Add<. Change the directory to
\Nt in the CD-ROM. Windows NT will now install the driver. The RME Settings dialog will open
automatically.
A click on 'OK' finishes the installation. After a reboot the DIGI symbol will show up in the
systray of the taskbar. The DIGITray tool will be loaded automatically each time when booting
NT.
A left mouse click on the DIGI96 symbol starts the 'Settings' dialog. The NT driver supports any
combination of up to three RME cards. The driver is installed only once for all cards in the
system.
User's Guide DIGI9652 © RME
5
Advertisement
Table of Contents
