Table of Contents
Advertisement
If your control surface model isn't listed
If you can't find your control surface listed on the Manufacturer or Model pop-up menus when you try to
add it, this means that there's no native support for that model. However, the program supports generic
keyboards and controllers. Here's what to do:
D Select "Other" on the Manufacturer pop-up menu and then select one of the three op-
tions on the Model pop-up menu.
Or, if the Manufacturer is listed but not your specific model:
D Select one of the three "Other" options on the Model pop-up menu:
In both cases, the options are:
•
MIDI Control Keyboard
Select this if you have a MIDI keyboard with programmable knobs, buttons or faders. You need to set
up your MIDI control keyboard so that the controllers send the correct MIDI CC messages, depending
on which Reason device you want to control - check out the MIDI Implementation Chart in the Reason
documentation. If your control surface has templates or presets for different Reason devices, these
can be used.
•
MIDI Control Surface
Select this if you have a MIDI controller with programmable knobs, buttons or faders (but without key-
board). Again, you need to set your controllers to send the correct MIDI CCs.
•
MIDI Keyboard (No Controls)
Select this if you have a MIDI keyboard without programmable knobs, buttons or faders. This is used
for playing only (including performance controllers such as pitch bend, mod wheel, etc.) - you cannot
adjust Reason device parameters with this type of control surface.
•
MIDI Multichannel Control Keyboard/Surface
These options can be used if your MIDI keyboard or surface can handle multiple MIDI channels simul-
taneously.
After selecting a model, proceed with selecting MIDI input as described above.
About the Master Keyboard
One of the control surfaces can be the Master Keyboard. This is like any other control surface, but it must
have a keyboard and it cannot be locked to a specific Reason device (in other words, it always follows the
MIDI input to the sequencer). This is the surface you use to play the instrument devices in Reason.
•
The first surface with a keyboard that is added (or found by auto-detect) is automatically
selected to be the Master Keyboard.
This is shown in the Attached Surfaces list on the Preferences page.
D If you want to use another surface as Master Keyboard, select it in the list and click the
"Make Master Keyboard" button.
You can only have one Master Keyboard.
D If you don't want to use any Master Keyboard at all, select the current Master Keyboard
surface and click the same button (which is now labeled "Use No Master Keyboard").
30
SETTING UP
Advertisement
Table of Contents
