Setting Up The Audio Hardware - Propellerhead Reason Installation Manual

Setting up the Audio Hardware

In case this wasn't done in the Setup Wizard, you need to establish a connection between Reason and the
audio hardware. This is done by selecting a driver - a software component that acts like a link between the
program and the audio hardware. Proceed as follows:
1. In the Preferences dialog, click the Audio tab.
2. Pull down the Audio card driver pop-up menu and select one of the available drivers.
Which driver to select depends on the platform and the audio hardware. If an option is not applicable to
your setup it will be disabled in the dialog.
25
SETTING UP