Brother P-Touch 2730 User Manual page 62

LABEL PRINTING
Setting
Large
Margin
Small
Margin
Chain
No Cut
Special
Tape
• When using Fabric Iron-On Tapes or Extra Strength Adhesive Tapes, refer to the above
"Special Tape".
• The tape is not cut after the last label is printed when "Chain" or "No Cut" is set. Hold down
the Shift key and press the Preview key to feed and cut tape automatically, or cut the tape
manually if you are using Fabric Iron-on Tapes or Extra Strength Adhesive Tapes.
58
Tape Cutting Options
Description
Automatically cuts the tape after each label is
printed, leaving a margin of 24 mm on each
end.
Automatically cuts a piece of blank tape
before printing the first label and then cuts the
tape after each label is printed, leaving a 4
mm margin at each end of each label.
• Automatically cuts a piece of blank tape
before printing the first label and then cuts
the tape after each label is printed, leaving
a 4 mm margin at each end of each label.
• Once the last label is printed, the tape is not
fed and cut.
• Prints a strip of labels with no cuts in
between.
• Pressing the Preview while holding down
Shift key will feed and cut the last label
printed.
• Select this setting when using special tape.
• When using Fabric Iron-On Tapes or Extra
Strength Adhesive Tapes, set "On" for
Manual Cutting before printing. After
printing, remove the tape cassette from the
machine and use scissors to cut the tape.
Tape Cutting
Example
ABC ABC
24 mm 24 mm
23 mm
ABC ABC
4 mm 4 mm
23 mm
ABC ABC
4 mm 4 mm
ABC ABC
24 mm 8 mm
ABC ABC
24 mm