Filling With Dishwasher Salt - Zanussi ZDT101 User Manual

Setting the water softener manually (see table)
Setting the water softener electronically (see table)
The water softener is factory set at position 5.
1. Press the On/Off button. The appliance
must be in setting mode.
2. Press and hold Programme selection/
Cancel button until programme light A
flashes and programme light B illuminates
with fixed light.
3. After a few seconds:
– programme light B turns off
– programme light A goes on flashing
– End of programme light starts flashing:
the number of flashes corresponds to
Set switch to position 1 or
2
A
The water softener is factory set at position 2.
B
current level set. The flashing is repea-
ted with a pause of a few seconds.
Examples: 5 flashes, pause, 5 flashes,
pause, etc... = level 5.
4. To change the level, press the Programme
selection/Cancel button. Each time the
button is pressed the level increases (level
1 follows level 10). The End of pro-
gramme light indicates the new setting.
5. To memorise the operation, switch off the
dishwasher.
11