Page 2
It should not be necessary to remove any protective earth or signal cable shield connections to prevent ground loops. Any such disconnections are outside the recommended practice of BSS Audio, and will render the EMC certificate void. We have written this guide with the aim of helping installers and sound engineers alike to get the most out of the 9010.
Page 3
Front panel LED functions Activity (yellow) Activity (yellow) Activity (yellow) Activity (yellow) Activity (yellow) Irregular Flashing - This LED indicates data transfer Sync (green) Sync (green) Sync (green) Sync (green) Sync (green) Steady - This indicates the presence of one or more valid network connections. Flashing - There is a problem with the incoming network signal - possibly the maximum cable length has been exceeded.
Page 4
Front panel details Display Contrast button Display Contrast button Display Contrast button Display Contrast button Display Contrast button This is used to optimise the contrast of the display. Press and hold the contrast button to adjust. If you go past the optimum setting, keep holding the button so that adjustment starts from the beginning again.
Page 5
Rear panel details Network In/Out* Network In/Out* Network In/Out* Network In/Out* Network In/Out* Network In - connects to the Network Out socket on another unit. Connecting multiple units is done in the same way - In to Out. Refer to the 9088 installation guide and Soundweb Designer help for further details. The connecting cable is CAT.
Page 6
Serial Port* Serial Port* Serial Port* Serial Port* Serial Port* Aux RS232 This is for connection to a PC if required. The 10-pin header is arranged so that a standard IDC ribbon cable will pin-out to an IDC D connector for standard PC RS232 connection.
Page 7
When using the 9010 unit with a 9011 power interface, connect as follows: Accessories Z Z Z Z Z -010-BEZEL Soundweb 9010 Bezel -010-BEZEL Soundweb 9010 Bezel -010-BEZEL Soundweb 9010 Bezel -010-BEZEL Soundweb 9010 Bezel -010-BEZEL Soundweb 9010 Bezel A sculptured plastic surround for the panel of the 9010 to ‘dress’...
Need help?
Do you have a question about the Soundweb 9010 and is the answer not in the manual?
Questions and answers