Regulatory Information - Pace DC50Xu Quick Start Manual

REGULATORY
INFORMATION
Your digital adapter has been tested and
found to comply with the limits for a Class
B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed
to provide reasonable protection against
harmful interference in a residential
installation. Your digital adapter
generates, uses and can radiate radio-
frequency energy and, if not installed and
used in accordance with the instructions,
may cause harmful interference to radio
communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If your digital adapter does
cause harmful interference to radio
or television reception, which can be
determined by turning your digital adapter
off and on, you are encouraged to try to
correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between your
digital adapter and the receiver.
• Connect your digital adapter to an
outlet on a circuit different from that to
which the receiver is connected.
• Consult your dealer or an experienced
radio/TV technician for help.
NOTE
CONNECTING TO THE
AC POWER SUPPLY
You must not plug your digital adapter into
the power supply until you have connected
your digital adapter to the other equipment in
your system.
Your digital adapter itself is designed for use
only with the supplied power supply unit.
On the power supply unit there is a label that
specifies the correct AC power supply input
for it. Do not connect the power supply unit
to any supply other than this.
Always connect the 5 volt DC cord from the
power supply unit to your digital adapter
before you insert the power supply unit into
the wall AC outlet.
To disconnect power from your digital
adapter, always remove the power supply unit
from the wall AC outlet (i.e. not by removing
the 5 volt cord from your digital adapter).
Therefore you must install your digital
adapter near to the wall AC outlet, which
should be easily accessible.
If you are in any doubt about the
power supply lead, its plug or its
connection, consult a qualified
electrician.