Table of Contents
Advertisement
DMT-8 Ver 2.0 Supplement to the Owner's Manual
After the completion of erase operation, "32 47 (<edit message=01 (completed)>)" will
be transmitted.
If erase cannot be executed due to improper figures of the pre-registered auto punch in
point/auuto punch out point, incorrect track section, etc., the corresponding edit message>
will be replied.
12 48: cut
When this command is received, D-80/DMT-8 ver2.0 will cut whole the section following
the pre-recorded auto punch in point under the assumption that whole the tracks are
nonrecorded section, With completion of the cut operation, this equipment will
immediately reply with "32 48 (<edit massage=01 (completed)>). "If cut is unexecutable
due to improper figure of the pre-registered auto punch in point, the corresponding
<edit message> will be replied.
12 49: clipboard play
When this command is received, D-80/DMT-8 ver2.0 will playback once from the head of
the sound data copied in the clipboard by the copy clip and move clip commands.
Immediately after receiving the command, D-80/DMT-8 ver2.0 will reply with "32 49
(<edit message=02 (active)><mmc track>)." The sound data track number is indicated
by (mmc track>.
Upon completion of playback, "32 49 (<edit message=01 (completed) is sent and clipboard
play is ended. If there is no sound data in the clipboard, "32 49 (<edit message=14(void
data)>)" will be sent and clipboard play operation will be interrupted.
12 4A: undo
Upon receiving this command, D-80/DMT-8 ver2.0 will revert to the condition prior to
editing copy paste, erase, move paste, cut redo operation. When completion of undo
operation, D-80/DMT-8 ver2.0 will reply with "32 4A (<edit message=01 (completed)>)."
If D-80/DMT-8 ver2.0 is not possible to undo, "32 4A (<edit message=00 (no message)>)"
will be replied.
12 4B: redo
When this command is received, D-80/DMT-8 ver2.0 will return to the condition prior to
undo operation.
With completion of redo operation, D-80/DMT-8 ver2.0 will reply with "32 4B (<edit
message=01 (completed)>).
If D-80/DMT-8 ver2.0 is not possible to redo, "32 4B (<edit message=00 (no message)>)"
will be replied.
12 4C: (<on/off>) : nondes.mode
The command for setting on/off of non destructive moded on D-80/DMT-8 ver2.0.
If <on/off> is set to "on," recording mode of D-80/DMT-8 ver2.0 will enter the non
destrucive mode, and if "off," in the destructive mode.
Nondes.mode:
Abbreviation for "non destrucive recording mode". When this mode is ON, not only
"takes" made by various sound editing or AUTO PUNCH IN/OUT but "takes" recorded by
simultaneous pressing of the PLAY and RECORD buttons (direct recording) will always be
possible to UNDO (However, free disc memory space equivalent to the recording length
will always be required). This is the same function of switching between "undo: ALL
(Nondes. mode: on)<– –> Edit (Nondes. mode: off)" in the setup menu on main unit.
34
Advertisement
Table of Contents
