GE GTDS850EDWS Installation Instructions Manual page 8

7 BATHROOM OR BEDROOM INSTALLATION
The dryer MUST be vented to the outdoors. See EXHAUST
INFORMATION section 3 & 4.
MOBILE OR MANUFACTURED HOME
8
INSTALLATION
I
s
F
(See EXHAUST INFORMATION section 3 & 4).
.
structure.
GARAGE INSTALLATION
9
r.
DRYER EXHAUST TO RIGHT, LEFT OR
10
BOTTOM CABINET
WARNING
Disconnect dryer from electrical supply.
Wear gloves and arm guards.
Close the back opening with cover plate
Electrical Shock
Failure to do so may result in electrical shock
Hazard
or lacerations.
* The internal elbow must be included in the total elbow count.
(See exhaust information)
Detach and remove the bottom, right or left side knockout
as desired. Remove the screw inside the dryer exhaust duct
and save. Pull the duct out of the dryer.
B
Cut the duct
as shown and keep portion A.
Installation Instructions
MANUFACTURED HOME CONS-
AMERICAN NATIONAL STANDARD
.
.
(IF ALLOWED BY LOCAL CODES)
(Kit WE1M454).
FIXING HOLE
A
14"
TAB LOCATION
BEND TAB
o
UP 45
-
Through the rear opening, locate the tab in the middle of
the appliance base. Lift the tab to about 45º using a flat
blade screwdriver.
e
ADDING NEW DUCT
FIXING
HOLE
Reconnect the cut portion (A) of the duct to the blower
housing. Make sure that the shortened duct is aligned with
the tab in the base. Use the screw saved previously to secure
the duct in place through the tab on the appliance base.
NOTE: the long vent model (GTDL740EDWW) is capable of
right side, rear and bottom venting only.
PORTION "A"
RIGHT OR
LEFT SIDE
EXHAUST