Rear Panel Connections And Settings - Parasound Zbreeze Owner's Manual

REAR PANEL CONNECTIONS AND CONTROLS
4
Connection Precautions
Disconnect the AC cord before making or changing any trigger wire connections.
Make sure there is no strain or tension on any wires that could cause them to pull loose.
Mode Switches for Turn On and Turn Off
Turn On Switch
The Turn On switch has three positions that control how the
Zbreeze is turned on.
• Man Manual Turn On: When this switch is set to its Man
position the Zbreeze is switched on and off with its front
panel Power button.
• AC Automatic Turn On: When this switch is set to its AC
position the Zbreeze will turn on automatically when the AC
outlet where its power cord is plugged in is turned on.
• 12V Automatic Turn On: When this switch is set to its 12V position the Zbreeze will turn on
automatically when an external 12 volt trigger voltage is applied to its 12V Trigger In jack.
Note: The AC and 12V switch positions disable the front panel Power button so the Zbreeze
turn on and off power is controlled only by the system controller. This way it can't inadvertently
be switched off.
12V Off Switch
The 12V Off switch has two positions which control how the
Zbreeze turns off while its turn on switch is set to 12V.
• Inst Instant Turn Off: When this switch is set to its Inst
position the Zbreeze is switched off as soon as the trigger
voltage at the 12V Trigger In jack is removed.
• Delay Delay Turn Off: When this switch is set to its Delay
position the Zbreeze continues to operate for approximately
10 minutes after the trigger voltage at the 12V Trigger In jack
is removed. After a 10 minute delay it will turn itself off. This is an important feature because it
allows equipment to cool quicker after power down.