Troubleshooting Pppoe - NETGEAR WNDR3700 - RangeMax Dual Band Wireless-N Gigabit Router Wireless Setup Manual

If your router is unable to obtain an IP address from the your service provider, the problem might
be one of the following:
• Your service provider might require a login. Ask your service provider whether they require
PPP over Ethernet (PPPoE) login.
• The service name, user name, and password might be set incorrectly. See
PPPoE".
• Your service provider might check for your computer's host name.
Assign the computer host name of your ISP account to the wireless-N gigabit router in the
Basic Settings screen.
• Your service provider allows only one Ethernet MAC address to connect to Internet, and
might check for your computer's MAC address. In this case, do one of the following:
– Inform your service provider that you have bought a new network device, and ask them to
use the wireless-N gigabit router's MAC address.
– Configure your router to spoof your computer's MAC address. This can be done in the
Basic Settings screen. Refer to the online help, which you can access from the wireless-N
gigabit router main menu.

Troubleshooting PPPoE

To troubleshoot a PPPoE connection:
Log in to the wireless-N gigabit router.
1.
Select Router Status under Maintenance on the main menu.
2.
Click the Connection Status button.
3.
4. If all the steps indicate OK, then your PPPoE connection is up and working.
5. If any of the steps indicate Failed, you can attempt to reconnect by clicking Connect. The
wireless-N gigabit router will continue to attempt to connect indefinitely.
If you cannot connect after several minutes, you might be using an incorrect service name,
user name, or password. There also might be a provisioning problem with your ISP.
Unless you connect manually, the wireless-N gigabit router will not authenticate
using PPPoE until data is transmitted to the network.
32
"Troubleshooting
Troubleshooting