Table of Contents
Advertisement
en
Operating the appliance
Operating
the appliance
P rogramme data
O p e r a t i n g t h e a p p l i a n c e
The programme data (consumption
values) can be found in the summary of
instructions. They refer to normal
conditions and the water hardness set
value
:
. Different influencing factors
such as e.g. water temperature or line
pressure may result in deviations.
A qua sensor *
Aq u a s e n s o r
* depending on model
The Aqua sensor is an optical
measuring device (light barrier) which
measures the turbidity of the rinsing
water.
The Aqua sensor is used according to
the programme. If the Aqua sensor is
active, "clean" rinsing water can be
transferred to the next rinse bath and
water consumption can be reduced by
3–6 litres. If the turbidity is greater, the
water is drained and is replaced with
fresh water. In the automatic
programmes the temperature and
running time can also be adjusted to the
degree of soiling.
20
Switching on the appliance
1. Turn on the tap fully.
2. Open the door.
3. Switch on ON/OFF switch (.
The Eco 50° programme display
flashes. This programme remains
selected if no other programme
button 0 is pressed. The expected
programme duration
flashes on the digital display 8.
4. Press the START button )".
5. Close the door.
The programme starts running.
Note
For ecological reasons the Eco 50°
programme is preset whenever
the appliance starts. This conserves
environmental resources and not least
saves you money.
Optical display while
the programme is running *
* depending on model
While the programme is running,
an optical display is indicated
on the floor under the appliance door.
If the base panel is pulled forwards
or if the appliance is installed at eye-
level with flush furniture front, the display
is not visible.
O p t i c a l di s p l a y w h i l e t h e p r o g r a m m e i s r u n n i n g
Hide quick links:
Advertisement
Table of Contents
