Table of Contents
Advertisement
Installation
Your Refrigerator Needs Air
For correct operation this appliance must be
located in a dry atmosphere, away from heat
sources, e.g. cookers, radiators, boilers and
direct sunlight.
You should also ensure that air can circulate
freely around the back and the top of the
cabinet. There should be 100mm (4") between
the top of the cabinet and any overhanging
kitchen furniture.
Alternatively allow 50mm (2") between the top of the cabinet and any
overhanging kitchen furniture and a gap of 25mm (1") on either side
of the appliance.
If your refrigerator is installed under
a continuous worktop, an air outlet
opening of at least 200 cm
ventilation grille (A/B) matching
the worktop design should be
installed at the rear of the worktop.
The cut surfaces of the worktop (C)
should be varnished to avoid swelling
due to penetration of moisture.
The appliance wall distance must be
at least 30 mm and should be
checked before the ventilation grille is inserted.
Special accessories:
A Ventilation grille, brown
B Ventilation grille, white.
Detaching the Worktop
After the worktop has been removed
the appliance can be installed under-
neath a continuous worktop.
The procedure is as follows:
1. Unscrew the Philips screws (F) on the
right and the left.
2. Lift the worktop slightly, push it about
20 mm towards the rear, and lift it off
upwards (G).
Unscrew the holding bracket (H) and keep it in a safe place.
8
105
and a
2
EG36
G
G 56/1
A/B
200 cm
C
570
550
93-103
F
H
2
Advertisement
Table of Contents
